Z10 integrated

For those who demand the best, but want to keep things simple. The Z10 Integrated amplifier delivers the magic, realism, and 3D soundstage of our patented ZOTL technology, all in one (gorgeous) box.

A single-component solution, the Z10 Integrated amplifier incorporates the acclaimed ZOTL10 power amplifier, a Berning-designed preamplifier, LTA’s digital control system, and an optional phono preamp–beautifully packaged in a Fern & Roby-designed case.

Powered by premium EL84 tubes, delivering 12 watts per channel, listeners enjoy startling realism, plentiful bass, low noise, plus gorgeous mids and highs.


Prices in Euro incl. vat excl. freight:

z10 integrated

z10 integrated incl MM riaa



High Quality Puritan Audio Laboratories mains cable 1 meter

High Quality Puritan Audio Laboratories mains cable 1,5 meter






Key specifications:

Inputs: 4 single-ended Cardas RCA stereo, 1 input using two 3-pin XLRs

Speaker Output: 4 WBT copper speaker binding posts, banana or spade

Headphone Output: Low: Approx. .5watt per channel at 50 ohms, High: Approx. 2 watts per channel at 50 ohms

Tape Monitor: 1 stereo tape monitor out, 1 stereo tape monitor in - both Cardas RCA

Front Panel Controls: 7 brass touch switches (power, input, tape monitor, up, down, menu/select, back), volume control, and headphone speaker switch

Remote Control: All front panel functions using paired Apple TV Remote (power on programmable)

Volume Control: 100 stepped attenuator (smallest step 1/1000th of total value) using Vishay Dale 1% precision resistors

Output impedance: 1.2 ohms

Input impedance: 47k

115VAC or 220VAC configured at factory - 50/60Hz - IEC receptacle

Hum and noise: 94dB below full output (measured at 20Hz-20kHz) • Carrier: -50dB (460kHz)

Power output with 4-ohm load: 13W, 0.5% THD

Power output with 8-ohm load: 12W, 0.5% THD

Frequency response (8-ohm load): 6Hz to 60kHz, +0, -.5dB

Amplifier class: Push-pull Class AB

Voltage gain (8-ohm load): 18dB

Size: 16 inches wide, 5 1/8 inches tall, 16 inches deep (including connectors)

Net weight: Amplifier: 18 lbs./8.2 kg

Finish: Aluminum case

Tube complement: premium NOS two 12AT7s, four 12AU7s, and four EL-84s or equivalents

Home Theater Function can select any input for fixed volume

Display: 16 Levels of brightness and programmable 7-second time out

Optional Phono Preamp: 46 dB gain for moving magnet cartridges.

Speaker sensitivity & room recommendation.

LTA amplifier owners have found great enjoyment using their amps with a variety of speaker outside of the below ranges. The below are guidelines, not rules. If you have questions about your specific speakers, chances are someone we know has tried them. Don’t hesitate to reach out with questions about your specific setup.

Critical listening environments: 90db sensitivity and above

Smaller rooms / lower volume levels / non-critical listening: 88db sensitivity and above.

Also, don’t forget we have a 14-day no-questions-asked return policy.

A couple of reviews & Videos:

“Here I am at the very end of my time with this unit, and I don’t want to send it back.” Zero Fidelity

The Z10 has a very realistic musical presentation. It plays music with wonderful harmonics and richness but with musically quick transience and exceptional bass control. Mentioning the bass, the Z10 was able to carry the music with a really good rhythmic drive. The bass was also very well defined, very tight, and there wasn’t the least hint of a “one-note bass.” There was also a very natural air around and within most of the bass instruments.

The Z10 does its magic in the midrange, which is where the Z10 breathes life into the recording. I could hear small differences in voices and breathing, and the instruments had a rich harmonic structure. On piano solos, it was much easier to hear the differences from one piano to the other.” The Audio Beatnik



LTA Heart.png